Sikafloor-2020, Single-Component Epoxy Paint, 20Kg
SIKA
Sika is a global leader in specialty chemicals for the construction and industrial sectors. The company develops and supplies innovative products and systems for bonding, sealing, damping, reinforcing, and protecting structures. With a strong focus on sustainability and performance, Sika serves a wide range of applications including concrete production, waterproofing, roofing, flooring, and structural strengthening.
Read moreOne-component, water-dispersed, colored acrylic coating Sikafloor®-2020 is a one-component, colored, water-dispersed acrylic sealant | |||||||||||||||||||||||||||||||||
UseSikafloor®-2020 is used to provide a decorative, dust-free finish for indoor and outdoor cementitious floors (without permanent exposure to water) in:
Advantages
pack15 l plastic buckets ColorLiquid Oxide red (~ RAL 3009), dark grey (~ RAL 7030), dark green (~ RAL 6010). All color references are approximate as shade may vary depending on application conditions. Other colors are available on request. | |||||||||||||||||||||||||||||||||
Typical technical data
| |||||||||||||||||||||||||||||||||
ApplicationLayer thickness ~ 120 μm dry film thickness for two layers (coating + coating) Ambient air temperature +10°C (+50 °F) min. / +30°C (+86 °F) max. The relative humidity of the air 80% u.r. max. Dew point Beware of condensation! The temperature of the substrate and uncured material on the surface must be at least 3˚C higher than the dew point, to reduce the risk of condensation and delamination of the finished surface. Note: Conditions of low temperatures and high humidity increase the probability of surface delamination. Support temperature +10°C (+50 °F) min. / +30°C (+86 °F) max. Moisture content in the substrate < 6 % pm moisture content. Test method: Sika®-Tramex-meter, CM - carbide measuring method or oven drying method. Rising moisture is not recommended, according to ASTM standards (polyethylene sheet test). Hardening time Before applying Sikafloor®-2020 over Sikafloor®-2020, a waiting time shall be allowed to allow the previous layers to cure.
Consumption ~0.12 - 0.15 l/m 2 per layer (~0.20 - 0.25 kg/m 2 per layer) The consumption depends on the conditions of the support layer such as permeability, profile, roughness and losses, etc. shuffle Sikafloor®-2020 is supplied ready to use and only needs to be thoroughly homogenised. Blending Tools: Sikafloor®-2020 must be thoroughly mixed using a low speed electric mixer (300 - 400 rpm) or other suitable equipment. APPLICATION Application can be done using a roller with short or medium hair or with a brush. CLEANING OF TOOLS Clean all application tools and equipment with water immediately after use. Already hardened material can only be removed mechanically. |